Cast Flooring Tool Kit

Laying your own screed? With this complete tool kit, you can get started right away. Check out our cast floors.

Contents standard tool kit:

• 4 rolls of masking tape
• 1 mixing rod
• 4 flat brushes (50 mm)
• 1 PU roller (25 cm)
• 4 pairs of gloves
• 1 smoothing trowel
• 1 tooth chip

Choice Guide

Use the information below to determine what additional materials you will need. The standard package is easily expandable.

Masking tape

For protecting walls and objects. Four rolls included. Need extra? Order from.

Mixing rod

For mixing components. Clean with acetone and paper towels for reuse.

Bucket

After mixing in the can, pour over into a bucket and mix again. For 3.5 liters, a 5-liter bucket is sufficient. For larger quantities, use a larger bucket. For concrete-look screeds, mix both colors in one bucket.

Tip: Use at least one bucket per coat.

Chip

Beginners use the flat trowel for the scraping layer and the tine trowel for the pouring layer. Advanced users can suffice with a flat trowel.

Brushes

For hard-to-reach areas. One brush per coat needed. Four pieces included.

Rollers

Use epoxy rollers for epoxy and PU rollers for polyurethane. One roller per coat required.

Personal protection

Wear long sleeves and long pants to avoid skin contact. Four pairs of gloves included.

Tip: Use one pair of gloves per person per layer.

Denim shoes

Walk over wet coating without leaving marks. Then finish with a roller.

Vent roller

Remove air bubbles for a tight end result.

Self-administered:

• Drilling machine for the mixing rod
• Roller bracket for the paint roller